Bondo off and on

Well, I forgot to take a before picture.  I was skiing with the family all day today and wanted to get this task done before a clean-up shower.  Here it is with a skim coat of bondo.  I'll let it set up this week and remove what I need to on Friday most likely.

I also went after the little blemishes that were the result of removing what was left of 3/4" pipe welded to the tub in three different spots.

This is the driver's side entrance point, top view.  A few ugly spots to be filled here, as well.

I turned my attention to dash panel.  It'd had bondo on it for a while, so I went after it with an orbital sander to get it down to final smoothness.  Again, not worried about it being perfectly flat, but I want the two patch panels not to show through the paint job.  You can see hints of them, of course, in the pic below, but that just means the bondo is doing its job leveling things out a bit (though not exactly).

Driver's side.

Center dash.

Passenger's side.

Job done.